Anadex DP-9000 - Page 40

POWER ON/OFF
ON/OFF LINE
VERT ALIGN
FEED
FORM FEED
TOF SET
Switch/Indicator for controlling main
power to the printer.
- Switch for placing printer ON or OFF
LINE. An adjacent indicator lamp indi-
cates status.
- A blank of three switches for vertical
paper alignment. These switches are
only operational when the printer is in
the OFF LINE mode.
- This switch, when depressed, causes the
paper to travel one line 'space. If the
switch is held down, paper feed resumes
after a short delay (,-v ~ sec) and will
then feed continuously until released or
Top of Form is reached. If the current
Form Length is 0, the feed is continuous
until released. This is a dual function
switch, see TOF SET for the alternate
function.
- Depressing this switch causes the paper
to be fed to the top of the next form,
unless current Form Length is 0, in
which case no action occurs. This is a
dual function switch, see TOF SET for
the alternate function.
- Depressing this switch when the printer
is OFF LINE establishes the current form
position as TOP OF FORM CTOF). This
switch is a dual function switch. When
depressed in combination with the FEED
switch~ the paper is stepped forward in
0.014 inch increments.
CAUTION
THE OPERATOR MUST TAKE CARE WHEN
FEEDING IN THE REVERSE DIRECTION TO
ENSURE THAT THE FEED IS SMOOTH AND
THAT THE PAPER IS NOT BUNCHED UP ABOVE
THE PRINT HEAD WHEN THE PAPER PERFORA-
TION
IS BETWEEN THE TRACTORS AND THE
PRINT HEAD.
When depressed in combination with the FORM
FEED switch, the paper is stepped in the
reverse direction in 0.014 inch increments.
When depressed in combination with the SELF
TEST
switch and with the ON LINE indicator
lit, SELF TEST is initiated.
3-2