Anadex DP-9000 User Manual

ESC % NN
ESC VN
ESC 7 NNN
ESC H
ESC I
BEL
FS
GS
- Set Skip-aver-Perforation. to NN lines.
(NN is an ASCII decimal number in the
range of 00 to 9ge) This number must
be less than the currently set Form
Lengthe
- Set or reset Auto Line Feed mode~ (N
is either ASCII 0 or l~) 0 resets Auto
Line Feed to "inactive"; 1 sets Auto
Line Feed to "sel·ected" e
- Set width of printing area to NNN tenths
of an inch. (NNN is an ASCII decimal
number expressing the printing area in
tenths of an inch in the range of 010 to
132.) This command also clears all
current Horizontal Tab Stops, and the
maximum number of printable columns is
recalculated based upon the new form
width and the current character font;
therefore, any required Horizontal Tab
Stops must be re-entered after changing
the form width.
- Set Vertical Spacing to 6 lines per inch
and zero form length. The proper Form
Length and Skip-aver-Perforation must be
retransmitted following this sequence to
reestablish the form length. If the
current position is not the true TOF,
then a line count to the true TOF position
should be made and form length established
at that time ..
- Set Vertical Spacing to 8 lines/inch and
zero form length. The same conditions
as for ESC H apply.
- ASCII Code 7 - Causes activation of an
optional audible device ..
- ASCII Code 28 - Enter Graphics mode.
(See paragraph 3.4.)
- ASCII Code 29 - Exits Graphics mode.
3-12

Anadex DP-9000 Specifications

General

Brand	Anadex
Model	DP-9000
Category	Printer
Language	English