Anadex DP-9000 - Page 52

PRINT ACTION
& VERTICAL
MOVEMENT
CR
LF
FF
VT
ETB
CAN
- These codes always close an open printing
record in addition to the commanded action.
Closing a printing record causes the
record to be printed.
- ASCII Code 13 - causes any open printing
record to be closed. If Auto Line Feed
is active, and a record is open, when CR
is received the record is closed and one
Line Feed is scheduled. In Automatic
Line Feed Mode receipt of a CR code
will always cause a line feed.
- ASCII Code 10 - causes an open printing
record to be closed. In any case, one
Line Feed is scheduled and activated.
- ASCII Code 12 - causes an open printing
record to be closed. If a non-zero Form
Length is set, the exact number of Line
Feeds is scheduled to position the form
at the next TOF location. If Line Feeds
are scheduled after the last printing
record, but before the FF code, the Line
Feeds are ignored. Additional Line Feeds
or Vertical Tabs after the FF code will
be acted upon.
- ASCII Code 11 - causes an open printing
record to be closed. One or more Line
:Feeds are scheduled to move the forni to
the next tab stop, higher than the current
position. If none are set, or no higher
stop is set, the form is moved to the next
TOF position. If no Form Length is set,
the VT code is ignored, except to close
the record.
- ASCII Code 23 - causes any open printing
record to be closed and printed. It
never causes Line Feeds to be scheduled.
This code may be used in lieu of CR when
in the AutQ Line Feed mode to prevent a
Line Feed occurring when the data is
printed.
- ASCII Code 24 - causes any open printing
record to be cancelled and closed. No
printing action takes place. If an ESC
sequence is occurring and not completed,
it is cancelled.
3-14