Need help?Do you have a question about the Analytik Jena SPECORD 200 PLUS and is the answer not in the manual?
General| Wavelength Range | 190 - 1100 nm |
|---|---|
| Wavelength Accuracy | ± 0.5 nm |
| Power Supply | 100 - 240 V AC, 50/60 Hz |
| Light Source | Deuterium lamp and Halogen lamp |
| Detector | Silicon photodiode |
| Measurement Modes | Absorbance, Transmittance |
| Data Output | USB, RS232 |
| Weight | 18 kg |
| Optical System | Double beam |
| Stray Light | < 0.1 % at 340 nm |
Emphasizes reading safety chapter, observing messages, and complying with all applicable regulations.
Highlights specific warning signs like UV radiation and hot surfaces found on the SPECORD PLUS device.
Details qualifications, training, and responsibilities for personnel operating the device safely.
Covers general operational safety, including ventilation, liquid ingress, vapor proximity, and electrical safety.
Specifies service by authorized personnel and outlines critical cleaning and repair precautions.
Provides detailed instructions for removing foam blocks and locking screws to prevent device damage.
Offers warnings and step-by-step guidance for connecting the SPECORD PLUS and PC, and software installation.
Guides on starting the device, software, and performing essential device initialization procedures.
Outlines essential maintenance tasks like cleaning, lamp replacement, and fuse replacement.
Details lamp service life and provides step-by-step instructions for replacing the deuterium lamp.
Offers safety warnings and step-by-step instructions for replacing the halogen lamp unit.
Details safety precautions and step-by-step instructions for replacing faulty fuses in the device.
To Next Page
