5
6
of the battery negative.
3 Don't cross the fuse of the device,
directly connect to the battery.
)
The installation of the device
1 First of all, take the original vehicle CD player out.
2 Remove the install bracket and screws and keep it.
3 Fix the bracket through the screws on the navigation system device.
4 Don't connect this product power wire directly to other power-line circuits.
5 Fix all the cables according to the hose diagram.
6 Install the navigation system in right position and then screw the bracket of
the original car to fix it well.
)
)
)
)
)
)
(Picture-01)
Note: Do not damage or dirty the Dashboard.
The installation of GPS antenna
GPS antenna
metal plate please peel
the paper at back
please sweep the
place to make sure
no dust,wet,oil or dirt
before you stick.
:Nt
OTE he metal plate
have powerful glutinosity to
leave the impress when you
remove it.
(Picture 02)-
1) To install the antenna in the inner of
the car(on the rear shell),please try to
make the metal plate stick on the
horizontal lever so that the GPS antenna
towards the window. GPS antenna will be
placed on the metal plate. ( GPS antenna
fixed by magnetic.) picture 02(-)：
When the lead contacts the up
of the car door to circle au-turn
in order to prevent the rain water
flows along the lead to the in-
house of vehicle.
GPS Antenna
Waterproof mat
Please make sure water-
proof mat to contact the
top of rubber pad.
Curving the lead to a circle
out side the rubber pad in
order to prevent rain water
flows along thelead vehicle
in-house.
(Picture 03)-
2 To install an external antenna (on the
car),GPS antenna will be placed in a
level position as far as possible, such as
roof or cover suitcase Department. ( By a
fixed magnetic body.) picture 02
)
(-):
NOTE: Paste the metal plates, should not
be cut it into small pieces. Some models of
vehicles do not allow glass windows GPS
satellite signal penetration. Then, the GPS
antenna should be installed at the outside of
the vehicle.
Other notice
Do not put remote control on the dashboard, the steering wheel or sunbaked
place, especially in the summer as the high temperature will lead to deformation
of the remote control. When the car stopped in the sun-baked place, the remote
control should be placed on storage boxes or sunproof area. Under direct
sunlight, the signal from the remote control may not be correct to receive by the
device. Therefore, please put remote control near the front panel of sensors.
If used the battery in a wrong way, due to rupture and leakage of electrolyte
and cause fever, fire, injury or failure, as well as the use of pollution around the
danger.
1) Please put the batteries in the remote after confirm the + and-of batteries.
2) Please use the batteries we suggested.
3) Please change the exhausted batteries in time for your better use.
Operation of remote control
On the proper use of batteries
Before the Operation
Before the Operation
To Next Page