14
1.75mm.
3.2 Increase the extrusion speed
If your filament diameter is correct, but you are still seeing under-extrusion
issues, then you need to adjust your extrusion speed. This is a very useful setting
in Anet3D printer control panel that allows you to easily modify the amount of
plastic that is extruded (otherwise known as the flow rate). You can find this
setting by turning the knob to enter “Configuration” .Specific setting process as
follows: Press the knob to enter the menu, choose “Configuration”, confirm， turn
to “motion”, confirm, find “Esteps/mm” tab, turn the knob to adjust extrusion
speed. The default value is 95mm/s, you can change it to 97mm/s. that means
the plastic will be extruded more 2mm/s than before. Try increasing your
extrusion speed and then reprint the test cube to see if you still have gaps
between your perimeters. Notice that increasing a little once to avoid extruding
too much plastic.
To Next Page
Loading...
