36
can help avoid grinding issues. In Anet3D control panel, you can press the knob
to enter the menu and choose “Configuration” and then choose “motion”,
find“Esteps/mm” to adjust extrusion speed. The default value is 95mm/s. you
modify it to 93mm/s. That means it will be 2mm plastic less extruded from the
nozzle per second. Decrease only a little once to avoid Not Extruding Enough
Plastic and then see if the filament grinding goes away.
10.3 Check for a nozzle clog
If you are still encountering filament grinding after increasing the temperature
and slowing down the print speed, then it’s likely your nozzle is partially clogged.
Please read the Clogged Extruder section for instructions on how to troubleshoot
this issue.
To Next Page
Loading...
