50
appropriate value. If you were previously using only 0.6mm solid layers, try the
same print with 1.2mm top solid layers to see if the foundation is improved.
16.3 Infill density is too low
The final setting you should check is the infill density. You will set the value
under the“Fill Density” tab of “Basic”. The top solid layers will be built on top of
the infill, so it is important that there is enough infill to support these layers. For
example, if you were previously using a infill percentage of 20%, try increasing
that value to 40% to see if the print quality improves.
To Next Page
Loading...
