Anet E10 - Page 3

6.1 Retraction distance .................................................................................. 21
6.2 Retraction speed ...................................................................................... 22
6.3 Temperature is too high ........................................................................... 22
7. Overheating ...................................................................................................... 24
7.1 Insufficient cooling ................................................................................... 24
7.2 Print at too high temperature .................................................................. 25
7.3 Printing too fast........................................................................................ 25
7.4 When all above fall, try to print multiple parts at once .......................... 26
8. Layer Shifting or Misalignment ........................................................................ 27
8.1 Nozzle moves too fast .............................................................................. 28
8.2 Mechanical or Electrical issues ................................................................ 29
9. Layer Separation and Splitting.......................................................................... 31
9.1 Layer height is too large ........................................................................... 32
9.2 Print temperature is too low .................................................................... 33
10. Grinding Filament ............................................................................................. 34
10.1 Increase the extruder temperature ....................................................... 35
10.2 Print too fast .......................................................................................... 35
10.3 Check for a nozzle clog ........................................................................... 36
11. Clogged Extruder .............................................................................................. 37
11.1 Manually push the filament to extruder................................................ 38
11.2 Reload the filament ............................................................................... 38
11.3 Clean out the nozzle .............................................................................. 39
12. Stops Extruding in the Middle of a Print .......................................................... 40
12.1 Out of filament ....................................................................................... 41