30
layers of the print. So if layer misalignment is a reoccurring problem, you should
verify that all of the motor fasteners are properly tightened.
There are also several other common electrical issues that can cause the
motors to lose their position. For example, if there is not enough electrical current
getting to the motors, they won’t have enough power to spin. It is also possible
that the motor driver electronics could overheat, which causes the motors to stop
spinning temporarily until the electronics cool down. While this is not an
exhaustive list, it provides a few ideas for common electrical and mechanical
causes that you may want to check if layer shifting is a persistent problem.
To Next Page
Loading...
