SET UP REQUIREMENTS
WHAT’S IN THE BOX
1
Nursery Unit
2
Tabletop stand/Wall Mount (for Nursery Unit)
3
2 x AC Adaptors
4
Parent Unit
5
Lithium Ion Battery Pack
(for Parent Unit)
6
Sensor Pad
7
CR2450 3V Battery (for Sensor Pad)
8
Hardware (for wall mounting)
WHAT YOU NEED
Hardboard, if the cot does not have a firm surface
(see specification on STEP 2).
Drill or screwdriver (for wall mounting).
2X
1
6
2
7
3
8
2X
5
4
• Be sure replacement parts are supplied by
Angelcare and have the same characteristics as
original part. Unauthourised substitution may result
in fire, electric shock or fire.
43. Unplug this appliance during lightning
storms or when not used for long periods of
time.
44. Servicing - DO NOT attempt to service
this product yourself as opening or removing
covers (except battery door) may expose you
to dangerous voltage or other hazards.
• Power Supply – see Technical Specification within
this guide.
45. Overloading - DO NOT overload wall outlets,
extension cords or integral convenience
receptacles as this can result in a risk of fire or
electric shock.
46. Nursery Unit Antenna - e antenna used
for this transmitter must be installed to provide a
separation distance of at least 8’’ (20 cm) from all
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
47. Cleaning - Disconnect all units before cleaning.
DO NOT immerse any part of the monitor in water.
Clean only with a dry cloth.
1 SETTING UP THE PARENT UNIT
Charge the Parent
Unit 8 hours
prior to first use.
Regular charging time
is 6 hours.
8H
1
3
2
E
N
5
To Next Page
Loading...
