Anglecare AC327 - Nursery Unit Setup and Placement; Cot Preparation for Sensor Pad

• If your cot does not have a solid, stationary, completely flat, firm
surface including a spring or slat base, place a hardboard between
the cot base and the Sensor Pad, to ensure correct operation. e
hardboard support must measure at least 30 x 30 cm
and 6 mm thick. is hardboard support must be larger than
the Sensor Pad surface area.
• e Sensor Pad functions with standard cot sprung and foam
mattresses and not memory foam (partial or full), hollow frame
construction mattresses and water beds. Please consult Angelcare if
unsure of mattress compatibility. e hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby’s movements
even when the baby is at the edges of the cot.
IMPORTANT
3 SETTING UP THE NURSERY UNIT
Tabletop
Sensor Pad
Wall-Mounted
(e mounting
height of the
Nursery Unit
should be less
than 2 metres.)
Place the Nursery
Unit and Adaptor
cord at least
1 metre
from the cot.
1
2
WALLMOUNTED
NOTE: Before fixing to the wall, review both wall mounted options to achieve best view for you.
Option 1 - Close viewing range (Guide 1.0 to 1.5 meters - wall to cot)
1 2 3
Option 2 - Furher viewing range (Guide 1.5 meters or more - wall to cot)
TABLETOP
1 2 3
2
3
1
4
Do not thread the cord
through the bracket hole.
E
N
7