Anritsu MS2690A - Page 1219

Chapter
４
Native Device Message Details
4-137
4
Native Device Message Details
Frequency Band:above30GHz
56M4L3-17G
CS:56MHz Class:4L
Frequency Band:3G-17GHz
56M4L17-30G
CS:56MHz Class:4L
Frequency Band:17G-30GHz
56M4LABV30G
CS:56MHz Class:4L
Frequency Band:above30GHz
56M5A6A3-17G
CS:56MHz Class:5A6A
Frequency Band:3G-17GHz
56M5A6A17-30G
CS:56MHz Class:5A6A
Frequency Band:17G-30GHz
56M5A6AABV30G
CS:56MHz Class:5A6A
Frequency Band:above30GHz
56M5B6B3-17G
CS:56MHz Class:5B6B
Frequency Band:3G-17GHz
56M5B6B17-30G
CS:56MHz Class:5B6B
Frequency Band:17G-30GHz
56M5B6BABV30G
CS:56MHz Class:5B6B
Frequency Band:above30GHz
When omitted CS:7MHz Class:2
When Standard is set to NXDN
(ACP Measurement)
pattern
Parameter to set
BW-6_25KHZ
BW-6.25kHz
BW-12_5KHZ
BW-12.5kHz
When omitted BW-12.5kHz
When Standard is set to NXDN
(Spectrum Emission Mask Measurement)
pattern
Parameter to set
47CFR-E_6_25KHZ
47CFR-E_6.25kHz
47CFR-D_12_5KHZ
47CFR-D_12.5kHz
When omitted 47CFR-D_12.5kHz
Details
This command is not available when Standard is set to Off.
Example of Use
To set the ACP measurement parameter type to 3GPP W-CDMA Uplink.
LOADSTD ADJ,UPLINK