Anritsu MS2690A - :TRACe[1]|2|3|4|5|6:STORage:MODE?

2.6 Trace
2-191
2
SCPI Device Message Details
:TRACe[1]|2|3|4|5|6:STORage:MODE?
Storage Mode Query
Function
This command queries the storage mode of trace data.
Query
:TRACe[n]:STORage:MODE?
Response
<mode>
Parameter
<n>
Target trace
1
Trace A
2
Trace B
3
Trace C
4
Trace D
5
Trace E
6
Trace F
When omitted: Trace A
<mode>
Storage mode
OFF
Does not store trace data.
MAXH
Holds the maximum value.
AVER
Executes Log averaging.
MINH
Holds the minimum value.
LAV
Executes Linear averaging.
Example of Use
To query the storage mode of Trace B.
TRAC2:STOR:MODE?
> AVER
Related command
This command has the same function as the following commands.
[:SENSe]:ACPower:AVERage[:STATe]?
[:SENSe]:CHPower:AVERage[:STATe]?
[:SENSe]:OBWidth:AVERage[:STATe]?
[:SENSe]:SEMask:AVERage[:STATe]?
[:SENSe]:BPOWer|:TXPower:AVERage[:STATe]?
[:SENSe]:SPURious:AVERage[:STATe]?