Anritsu MS2690A - TRGS;TRGS?

Chapter
４
Native Device Message Details
4-343
4
Native Device Message Details
Example of Use
To set the threshold value of the level where trigger sweep starts to –10
dBm.
TRGLVL -10DBM
TRGLVL?
> -10
TRGS/TRGS?
Trigger Switch
Function
This command sets trigger sweep ON/OFF.
Command
TRGS switch
Query
TRGS?
Response
switch
Parameter
switch
Trigger sweep ON/OFF
FREE
No trigger sweep (Free Run)
TRGD
Sweep when triggered (Triggered)
Details
This command is not available when Signal Generator Control is On.
Example of Use
To set to wait for a sweep trigger.
TRGS TRGD
TRGS?
> TRGD