Anritsu MS2690A - SWP;SWP?

Chapter
４
Native Device Message Details
4-336
SWP/SWP?
Single Sweep/Sweep Status Query
Function
This command sets the sweep mode to single and starts single sweep.
Also, it reads the sweep status (sweep done/during sweeping).
Command
SWP
Query
SWP?
Response
status
Sweep status
0
Sweep done
1
During sweeping
Details
Starting sweep with this function makes the following command wait
without being processed until sweep is finished.
Example of Use
To start single sweep and read the sweep status.
SNGLS
SWP?
> 1