Anslut 013947 - Page 71

EN
72
explosion.
• The product has wheels to
make it easy to move. Do not
use the wheels on soft
carpets and do not attempt
to roll the product over
objects, it can tip over.
• Do not use the product if the
power cord or plug are
damaged, if the product has
been in contact with water, is
not working properly, or if it
is damaged in any other way.
• If the product has an electric
heater it must not be placed
closer than 1 metre to any
ammable material.
• Do not handle the product,
power cord or the plug with
wet hands.
• Switch o the product
immediately and pull out the
plug if the product tips over
when in use. Check for any
visible damage to the
product. Contact an
authorised service centre or
other qualied personnel if
the product is damaged.
• Switch o the product and
pull out the plug during
in the power point. The
power point must be fused
for the product’s maximum
power consumption
(specied on type plate). Do
not use an extension cord.
• Place the product on a level,
stable surface. Otherwise
there is a risk of material
damage, noise and/or
vibration. Do not cover or
block the ventilation
openings on the product –
risk of personal injury,
material damage and/or
malfunction.
• Connect the product to a
separate power circuit. An
incorrect connection to the
mains supply can result in a
risk of re and/or electric
shock.
• Do not use the product in
damp or wet areas. The
penetration of water can
cause the electronic
components to stop working.
• Do not use the product in
explosive environments, such
as in the vicinity of
ammable liquids, gases or
dust – risk of re and/or