Anslut 013947 - Maintenance

EN
84
6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13,
14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24 hours.
EXAMPLE OF TIMER SETTING:
TIMER ON (automatic start)
The TIMER ON function is useful, for example,
to start the air conditioner automatically before
you get home.
Example:
Follow the instructions below to set automatic
start in 6 hours:
1. Press the button TIMER ON. The display on
the remote control shows the last set start
delay and the status in h.
2. Press the TIMER ON button repeatedly
until 6:0h is shown on the display on the
remote control. Wait about 3 seconds
until the temperature display is reset. The
function is now enabled.
FIG. 24
TIMER OFF (automatic switching o)
The TIMER OFF function is useful, for example,
to switch o the air conditioner automatically
after you have gone to bed.
Example:
Follow the instructions below to set automatic
stop in 10 hours.
1. Press the button TIMER OFF. The display on
the remote control shows the last set stop
delay and the status in h.
2. Press the TIMER OFF button repeatedly
until 10h is shown on the display on the
remote control. Wait about 3 seconds
until the temperature display is reset. The
function is now enabled.
FIG. 25
TIMER OFF – TIMER ON (on — stop — start)
This function is useful, for example, to switch
o the air conditioner after you have gone to
bed and to start it again before you get up.
Example:
Follow the instructions below to set automatic
stop in 2 hours and automatic start in 10 hours.
1. Press the button TIMER OFF.
2. Press the TIMER OFF button repeatedly
until 2.0h is shown on the display on the
remote control.
3. Press the button TIMER ON.
4. Press the TIMER ON button repeatedly
until 10h is shown on the display on the
remote control. Wait about 3 seconds until
the temperature display is reset.
FIG. 26
TIMER ON – TIMER OFF (o — start — stop)
This function is useful, for example, to start the
air conditioner before you get up and to switch
it o after you have left the house.
Example:
Follow the instructions below to set automatic
start in 2 hours and automatic stop in 5 hours.
1. Press the button TIMER ON.
2. Press the TIMER ON button repeatedly
until 2.0h is shown on the display on the
remote control.
3. Press the button TIMER OFF.
4. Press the TIMER OFF button repeatedly
until 5.0h is shown on the display on the
remote control. Wait about 3 seconds until
the temperature display is reset.
FIG. 27
IMPORTANT:
The mode that comes up rst (TIMER ON or
TIMER OFF) takes place rst.
SLEEP
The SLEEP function produces a comfortable
temperature and saves energy when you are
sleeping. The function can only be used in
COOL and AUTO mode. Further information is
available in the instructions.
NOTE:
If the air conditioner is in SLEEP mode this
is interrupted if the ON/OFF, FAN SPEED, or
MODE button is pressed.
MAINTENANCE