EasyManua.ls Logo

Anslut 013947 - CLEANING AND CARE; Drain Hose Connection; Water Level Warning (P1); Air Filter Maintenance

Anslut 013947
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
85
CLEANING AND CARE
WARNING!
Pull out the plug before cleaning and/or
maintenance.
Do not use ammable chemicals for
cleaning.
Do not pour water on the air conditioner
– risk of electric shock.
Do not use the air conditioner if
electrical parts have been exposed to
water.
A damaged power cord or plug must be
replaced by an authorised service centre
or other qualied personnel to ensure
safe use.
Drain hose
1. In dehumidication mode remove the drain
plug on the back of the air conditioner and
connect a drain hose (sold separately).
2. Use a 3/4’’ hose with 5/8’’ coupling with
internal thread. For models without a drain
coupling, connect the drain hose to the
hole.
3. Put the end of the hose in a suitable drain.
FIG. 28
NOTE:
Check that the hose and coupling are
tight. Make sure the hose is not creased
or clenched. Lead the hose to a suitable
drain and make sure that the end of the
hose points down.
If continuous drainage is not being used,
check that the drain plug and knob are
properly inserted to prevent leakage.
Water level warning
1. When the water level in the collector
tank reaches the specied level the air
conditioner gives 8 audio prompts and
the display shows P1.
2. The air conditioning/dehumidication
stops, but the fan continues to run.
Carefully move the air conditioner to a
suitable drain, remove the bottom plug
and allow the water to run out.
3. Replace the bottom drain plug and start
the air conditioner. P1 disappears from
the display. Contact the retailer if the fault
persists.
FIG. 29
NOTE:
Remember to rmly replace the bottom drain
plug before starting the air conditioner to
avoid leakage.
Remove the air lter
Remove the air lter as shown in the diagram.
FIG. 30
Clean the air lter every other week for
best functionality.
Empty the tank as soon as the warning
code P1 is shown. Always empty the tank
before putting away, otherwise there is a
risk of mould accumulating.
If there are any pets in the house, clean
the grille regularly from hairs that can
block the ow of air.
NOTE:
Never use the air conditioner without a lter
– dust and impurities will reduce its capacity.
CLEANING
Clean the air conditioner with a soft cloth
moistened with a mild detergent. Wipe
with a dry, lint-free cloth afterwards.
Clean the casing and front with a soft,
oil-free cloth, or with a cloth moistened
with a mild detergent. Rinse and wipe dry.
Do not use strong abrasive detergents,
wax or polish on the front of the casing.
Clean the control panel with a dry or
lightly moistened cloth.
The penetration of water can cause the

Related product manuals