Anthem MRX520 - Speaker Connections

9
SPEAKER CONNECTIONS
Using speaker wire, connect the positive (+) connection on the speaker to the positive
(+) binding post on the appropriate amplier output, and the negative (–) connection
on the speaker to the negative (–) binding post on the same amplier channel using
cable that is insulated to handle the maximum output of the amplier. Carefully
remove insulation using a wire stripper.
Do not connect more than one speaker to each amplier output. Be sure that power
is turned off when connecting or disconnecting anything, and that the speakers are
rated for use with this receiver.
US models allow banana connectors. If using them, rst turn the binding post until it is
closed to allow the plug to be fully inserted.
If using speaker cables with banana connectors, rst turn the binding post until it is
closed. This way, the plug can be fully inserted.