24
AUTO OFF
When there is no input signal the receiver will turn off after the selected time: 5, 10, or
30 minutes, 1, 2, or 6 hours, or Never.
IP CONTROL
With this setting you can enable/disable response to networked Internet Protocol
commands.
STANDBY IP CONTROL
When disabled, the receiver goes into a low-consumption standby mode and does not
sense IP commands while in it. To make it respond to a power-on command, enable
this setting. This can also be used with RS-232 control to avoid sending a wake-up
command.
STANDBY HDMI BYPASS
This option allows use of an HDMI source without turning on the receiver. Select HDMI
1-7 or Last Used. The standby LED on the front panel changes to red. Your TV may
need setup to allow the sound to come from its speakers – check its manual.
3.8 GENERAL CONFIGURATION
This menu contains power saving, control, and tuner options.
General Configuration
Auto Off 30 minutes
IP Control On
Standby IP Control On
Standby HDMI Bypass Off
CEC Control Off
CEC Power Off Control Disabled
CEC Power On Control Disabled
FM Tuner Steps 100 kHz
To Next Page
Loading...
