22
3.7 NETWORK / REMOTE CONTROL
DEVICE NAME:
This is the name that the receiver broadcasts, and can be changed using up to 16
characters.
Network / Remote Control
Network Status
Device Name MRX 520
IP Configuration
Trigger Configuration
TCP Port 14999
Rear IR On
Front IR On
Tx Status On
Control4 ID Tx
IP CONFIGURATION
Settings in this submenu should only be changed if your network administrator gives the
direction or if using Direct Connect to run ARC.
MODE
Static IP settings take effect once this is changed to Manual.
TRIGGER CONFIGURATION
When the receiver’s trigger output is connected to the trigger input of another
component, such as an amplifier or projector, the receiver can turn it on or off according
to the trigger’s setup.
IP Configuration
Mode Auto (DHCP)
IP 192.168.000.001
Subnet Mask 255.255.255.000
Trigger Configuration
Trigger Control Menu
Power Main or Zone 2
HDMI 1 Off
HDMI 2 Off
HDMI 3 Off
FM Off
To Next Page
