How to fix wrong output data exported from Anton Paar Measuring Instruments?
If your Anton Paar Measuring Instruments exports wrong output data, the settings in the "Result Output" menu are likely incorrect. To fix this, change the settings in that menu.
What does 'Filling Warning' mean on my Anton Paar DMA 4100 M?
A 'Filling Warning' on your Anton Paar Measuring Instruments indicates that there are gas bubbles in the measuring cell. To resolve this, degas your sample and fill the sample at a higher temperature than the measuring temperature.
What to do if my Anton Paar Measuring Instruments calibration failed?
If the calibration of your Anton Paar Measuring Instruments fails and the results deviate from reference values, consider the following possible causes and solutions: 1. Inadequate cleaning and drying: Improve your cleaning and drying procedure. 2. Expired calibration liquid: Use a fresh calibration liquid. 3. Adjustment issues: Improve your adjustment routine.
What to do if my Anton Paar DMA 4100 M Measuring Instruments calibration failed and results deviate from reference values?
If the calibration of your Anton Paar Measuring Instruments fails and the results deviate from reference values, consider the following possible causes: inadequate cleaning and drying procedures, use of calibration liquid that has been stored for too long, or adjustment problems. You should improve your cleaning and drying procedure, use a fresh calibration liquid, and improve your adjustment routine.
General| Measurement Principle | Oscillating U-tube |
|---|---|
| Viscosity Correction | Yes |
| Measuring Range (Density) | 0 to 3 g/cm³ |
| Accuracy (Density) | 0.0001 g/cm³ |
| Repeatability (Density) | ±0.00005 g/cm³ |
| Temperature Accuracy | 0.03 °C |
| Temperature Repeatability | ±0.01 °C |
| Sample Volume | 1 mL |
| Display | Color display |
| Connectivity | USB, Ethernet |
| Data Storage | 1000 results |
| Power Supply | 100-240 V |
To Next Page
