EasyManua.ls Logo

Anton Paar SmartRef - Bluetooth Regulatory Compliance; Regulatory Compliance Statements

Anton Paar SmartRef
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
BLUETOOTH REGULATIONS
Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication. Conformément à la réglementation d’Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage radilectrique à l’intention des autres utilisateurs, il faut choisir
le type d’antenne et son gain de sorte que la puissance isotrope rayone équivalente (p.i.r.e.) ne dépasse pas l’intensité
nécessaire à létablissement d’une communication satisfaisante.
USA
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Taiwan
注意 ! 依據 低功率電波輻射性電機辦法第條 經型式認證合格之功率射頻電機,非經許可商號或使用者
不得擅自變更頻率、加大功率或變更原設計之特性及功能第十四條 低功率射頻電機使用不得影響飛航安全及干擾合法通
經發現有干擾立即停用改善至無干時方得繼使用。信,指依電信定作業之線電信。
率射頻電機須忍受合法通信或工業學及療用電波輻射性電機設備之干擾。
Japan
TELEC Certicate: R 201-160496
South Korea
KC Certicate MSIP-CRM-ryt-MDBT42Q
China
SRRC Certicate: CMITT ID: 2016DJ4571

Related product manuals