Anybus Wireless Bolt Reference Guide

AT Commands 57 (88)
3.8.15 AT*AMLCR Layer 2 Configuration Receiver
Configure AT over layer 2 (Ethernet)
AT*AMLCR=
Set AT over layer 2 configuration
Syntax:
AT*AMLCR=<eth_type>,<enable>,<store>
Input Parameters:
Name
Type Description
eth_type Integer 16 bit Ethernet type that should be used for AT commands
enable Boolean 0: Disable AT over Ethernet
1: Enable ATover Ethernet
store Boolean If store is 1 the new value is stored permanently.
Requires a reboot for the changes to take effect.
AT*AMLCR?
Get AT over layer 2 configuration
Syntax:
AT*AMLCR?
Example:
AT*AMLCR?<br>*AMLCR:<eth_type>,<enabled>
3.8.16 AT*AMREBOOT Reboot
AT*AMREBOOT
Reboot device
Syntax:
AT*AMREBOOT
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7

Anybus Wireless Bolt Specifications

General

Brand	Anybus
Model	Wireless Bolt
Category	Network Hardware
Language	English