AnyCubic MEGA ZERO - Page 39

Introduction to slicing software
5. Slice and preview
After setting the printing parameters, click the "Slice" button in the
lower right corner of the software. After the Slice is finished, click the
"preview" button to preview the simulated printing effect in the preview
view.
© 3 hours 28 minutes fi}
Previ.
Click tb preview the
simulated printing effect ——>
bere eer a % iew view.
aN
E cee
© 3 hours 28 minutes °
Wh 23g -s137
—
6. Print online
After the parameters have been set up, you can print online via Cura.
Click the "MONITOR" on the main interface. If the printer is not
connected properly, the interface will be blank.