AnyCubic MEGA ZERO - Page 38

Introduction to slicing software
Note: as shown in | |
the figure on the
right, the gray color
of the model
indicates that the
model is out of print
range.
After importing the model, users can customize the printing parameters
according to individual needs. But the configuration files that we
provide are suggested.
Note: "Suggested parameters MEGA-ZERO-PLA-V1.0. curaprofile” file is
prepared for PLA filament, and "Suggested parameters MEGA-ZERO-
TPU-V1.0. curaprofile" file is prepared for TPU filament.
Print settinc x
Profile Suggested parameters MEGA-ZERO-PLAVI.0 ...v
i
= quality
Shell <
Sf Infill ‘
ll Material
Note: The “Build Plate
Adhesion Type”
parameter needs to be set
\ Mesh Fixes <
2
Special
Modes
<
to
“None”
when
printing
4 Experimental <
the maximum size modle.