AnyCubic MEGA ZERO - Page 47

Troubleshooting
12.
@
@
®@
®
. The model looks normal but some parts cannot be printed
Special parts such as overhanging part need to be added with
support, etc., and need to be adjusted according to the specific
model. It is recommended to preview the print layer to see if it
meets the requirements.
Drawing is more serious
The retraction distance is insufficient. It should be set larger when
slicing.
The retraction speed is too slow. It should be set a bit faster when
slicing.
The printing temperature is too high, which causes the fluidity and
viscosity of the filament to be strong. The printing temperature
need to be set lowered a little.
Thank you for purchasing ANycuBi¢ products! Under normal usage and
service, the products and its parts have a warranty period up to one
year. Please visit ANvcubi¢ official website (www.anycubic.com) for
more details and report any issues with Anvcupic products. Our
professional after-sale service team would response within 24 hours
and help you to solve the issue.