1.7 How to Charge
WARNING:
»
When keys, ornamental chain or other electric metals contact the
battery terminal, the battery may become damage or injure a human.
If the battery terminals are short circuited it will generate a lot of heat.
Take care when carrying and using the battery. Remember to put the
battery or radio into an insulated container. Do not put it into a metal
container.
1. Plug the AC adaptor into the AC outlet, and then plug the cable of
the AC adaptor into the DC jack located on the back of the charger.
The indicator light blinks orange and is then ready to charge a
battery.
2. Plug the battery or the radio into the charger. Make sure the battery
terminals are good in contact with charging terminals. The indicator
light starts to blink red--- Pre-charging begins.
3. After pre-charging for about 5 minutes, the red indicator will stop
blinking--- charging begins.
4. It takes approximately 2 - 5 hours to fully charge the battery. When
the lamp lights green, the charging is completed. Remove the
battery or the radio unit with its battery from socket
»
when charging a radio (with battery) the indicating lamp will not
turn into green to show the fully charged status if the radio is
powered on. Only when the radio is switched off will the lamp
indicate normal operation. The radio consumes energy when it
is power-on, and the charger cannot detect the correct battery
voltage when the battery has been fully charged. So the charger
will charge the battery in constant voltage mode and fail to
indicate correctly when the battery has been fully charged.
To Next Page
Loading...
Need help?
General
