AnyTone AT-D868UV User Manual

15
AT-D868UV Digital DMR and Analog UHF/VHF Two Way Radio
Making a Call
You can choose a target radio via 3 methods.
Method 1: from the Channel switch.
Turn the channel switch to choose a programmed channel.
Method 2: from the Contact list.
1.Turn the channel switch to choose a programmed channel;
2.Press exit key to enter the Contact List, press the UP/DOWN key to
choose a contact.
Method 3: from the keypad.
1.Turn the channel switch to choose a programmed channel.
2.Press Menu key to Contacts, press select to enter Contacts.
3.Press UP/DOWN key to Manual Dial, press Select.
4.Input the ID number by keypad, press # key to switch group ID or
Private DMR ID.
Hold the radio vertical 2.5-5cm from your mouth, press the PTT key
to start the call, the red LED lights up, the receiver ID/name/city/state/
country/call type and call out icon will be display on the LCD.
Release PTT key to receive the reply.
2.12 Receiving and Responding to a Radio Call
When the radio is in the digital mode, it can receive and respond to a
call with the same frequency/color code/ slot.
When receiving a call:
1. If the radio is programed with callers DMR ID number in the digital
contact list, when receiving a call, the radio will ring or vibrate briey.
2. The blue LED lights up.
3. The left top corner of LCD shows the RSSI icon, and the LED
display will show DMR ID/name/city/state/country/call type and
incoming icon based on what is in the contact list.
4. When the call is ended, it will display “Call end”, and you can press
PTT to respond the call.

AnyTone AT-D868UV Specifications

General

Brand	AnyTone
Model	AT-D868UV
Category	Two-Way Radio
Language	English