AnyTone AT-D868UV User Manual

11
AT-D868UV Digital DMR and Analog UHF/VHF Two Way Radio
2.1 Programmed Key
In PC software – Public - Optional Setting - Key function, it is possible
to set different functions for PF1, PF2, PF3, P1, P2 keys.
OFF No Function
Voltage Check the current battery capacity voltage
Power
Switch the power between super high, high, middle and low
power.
Repeater Switch between talk around and repeater mode
Reverse Turn on/off the frequency reverse function.
Digital
Encryption
Choose the encryption group
Call
In Analog mode, send the DTMF/5TONE/2TONE encode. This
function is only valid for analog channel.
TBST
In Analog mode, send the tone pulse frequency signal to active
the repeater.
VOX Set up the VOX level
VFO/MR Switch between VFO mode and memory channel mode.
Sub PTT Sub channel PTT, press to start the call on sub channel
Scan Scan on/off
FM Radio FM radio on/off
Alarm
Long press the key to start alarm, short press again to exit the
alarm.
Record switch Enable/disable the recording function
Record
Start/stop recording. When stop recording, the radio will remind
repeat or send the record.
SMS In digital mode, press to enter into messages
Dial Start the manually dial
GPS Check the GPS position information
Monitor Monitor the weak signal or the signal with unmatched ID.
Main channel
switch
Choose channel A or channel B as the main channel
Hot key 1~6
Press the key to perform the programmed function in hot key
setup
Alone Turn on/off the work alone function.

AnyTone AT-D868UV Specifications

General

Brand	AnyTone
Model	AT-D868UV
Category	Two-Way Radio
Language	English