Extra
DDC/CI
Orbit
Yes
Weak
Resolution:2560(H)x1440(V) SDR
Off
H.Frequency:89 KHz
Input Select
OFF-RS
V.Frequency:60 Hz
Auto
Off Timer
Exit
USB
0
Enter
THAT
Image Ratio
Select
Off
Wide
On
Extra
On/Off Turns on/off the USB function.
Off (off) / Weak (weak) /
Enable/disable DDC/CI support.
Auto (automatic) / HDMI1 /
Turn on the image shift function to reduce the risk of image retention. The
recommended setting is "On". After
it is turned on, the image pixels will move cyclically as a whole, and the
moving range is related to the setting strength, and the moved characters
may be trimmed. When Strongest is selected, image retention is least likely
to occur, but possible cut edges are most noticeable.
0-24 hours
LEA
(Area Image Retention
Prevention)
On (open) / Off (close)
Image Ratio
USB
Orbit
(image offset)
/23.6"W(16:9) / 24"W(16:9)
Input Select
Medium (medium) /Strong (strong)
Turn on and run Screen Compensation Correction and Image Sticking
Removal to eliminate image sticking that may have
occurred. After turning it on, select "Yes" according to the menu prompts, and the
monitor will automatically run screen compensation correction first, and then run
image retention elimination. After the end, the power indicator light is off or orange,
and the monitor enters a shutdown or standby state.
Select DC timer shutdown.
Wide / 4:3 / 1:1 / 17"(4:3) /
19"(4:3) / 19"(5:4) / 19"W(16:10) /
21.5"W( 16:9)
DDC/CI
HDMI2 / DP1 / DP2
On (open) / Off (close)
Off timer
Adjust image scale.
Turn on the zone image sticking prevention function to reduce the risk of image
sticking. The recommended setting is "On". When enabled,
the brightness of the fixed display area at the four corners of the screen will be
automatically reduced to reduce possible image retention.
Off RS
(Image Retention Reduction)
Yes (Yes) or No (No)
Select the input signal source.
/ Strongest
(scheduled shutdown)
/ 22"W(16:10)/ 23"W(16:9)
28
Machine Translated by Google
To Next Page
Loading...
