AOC SPEAKER O3 - Play Audio through USB

16 EN
Key & Operate Action
Press key
on master
speaker
Select Play/pause the
music on all connected
speakers
Press VOL +/－
key on master
speaker
Increase or decrease
volume on all
connected speakers
Press DBB
key on master
speaker
Change DBB setting on
all speakers
Press and hold
power key on
master speaker
for 3 seconds
Power o master
speaker, all slave
speakers will exit party
link mode
Press and
hold key on
selected slave
speaker for 3
seconds
Power o selected
slave speaker, there
is no eect on master
speaker and other
slave speakers
Press and
hold key
on selected
speaker in
standby state
Power on selected
speaker and pressing
PartyLink key again to
enter PartyLink mode
Press key on
master speaker
Change light mode in
all connected speakers
Press key on
slave speakers
No change light mode
in all connected
speakers
Press and
hold key on
master speaker
for 3 seconds
Change brightness in
all speakers
Press PartyLink
button on
selected slave
speaker
Disconnect selected
slave speaker from
master speaker
Press and hold
PartyLink
button on
master speaker
for 3 seconds
Disconnect all
speakers and exit
PartyLink mode
Change to Audio in and USB source
In PartyLink mode, plug USB/AUX device
to master speaker, source will switch to
USB/AUX source.
1
1
2
Audio in
2
Audio in Audio out Audio in
1
1
2
Audio in
2
Audio in Audio out Audio in
Master speakerMaster speaker
PartyLink between AOC SPEAKER
O1, O2 and O3
You can connect SPEAKER O3 with
SPEAKER O1 and O2 Bluetooth speakers
under PartyLink mode.
When PartyLink is connected, the slave
speakers will synchronize from master
speaker of below functions.
• Volume level
• Play/pause
Play audio through USB
Enjoy audio on a USB storage device,
such as an MP3 player and USB ash
memory, etc.
Note
• Make sure that the USB device contains
playable audio contents in supported formats.
Supported formats: MP3, WAV, WMA, FLAC.
FLAC format audio only supports not over 16
bit rate and 1M code rate.
• The unit supports max 128G USB and the
format FAT16/FAT32/exFAT.
• Support a USB port: 5V 0.5A.