c) Displaying, deleting and printing stored Measurements
After first choosing the "MEM R" function from the memory programming menu, the "MR" icon is displayed.
The program displays the measurement value for the last object and the last test saved.
Example: object 1 and test 4 are displayed:
01 : 04.
OBJ : TEST
The "test" units figure blinks; you can then change the object and test numbers using the arrow keys.
The stored measurement value is displayed. Inaccessible objects and tests are those locations that are still
available.
When the measurement is viewed, the following measurement components are displayed:
The number of the object and test that correspond to the memory location.
The measurement value with any compensation used.
R (θ) display for the type of metal, if the measurement was compensated.
The alarms that were active during the measurement.
The active range and current levels during the measurement.
The parameters set for the alarm threshold, reference temperature, ambient temperature and metal correction
coefficient are not directly accessible but require a key to be pressed.
Other keys that are active when viewing the memory contents:
For compensated measurements, displays the reference temperature value and the
ambient temperature level when the measurement was taken.
To Next Page
Loading...
