E.6 Updating the On-board Software
If any changes are made to the unit, software updates are available from the AOIP website at:
http://www.aoip.fr/ along with a procedure for using them.
The "UPG" function included in the maintenance menu (refer to the Managing Maintenance sub-section) lets
you update the unit's program.
After validation, five lines appear on-screen. The unit is now ready to communicate with the computer to
download the new program version.
Then follow the instructions displayed on the computer screen.
The transmission speed used for this update function is 19200 baud. Once the update is completed, the unit
initialises just like when it is started up normally.
Important: Any shutdown performed without first completing the update will make it impossible to restart the
unit. Downloading must be resumed after first replacing the unit in the await transfer mode. To do this, hold
the OPER key down for five seconds and restart the unit without releasing the OPER key: The AL1 and AL2
LEDs will blink, then release the OPER key once they have stabilised.
The "await transfer" mode is now active.
To Next Page
Loading...
