{figure 45}
3.2 Memory channel
In the memory channel mode, either rotate the main dial to select the memory
channel or use the [←] [→] keys. Memory channels with no valid data will be ignored
(skipped = not shown).
3.3 Memory bank
In the memory mode, press the [BANK] key. The LCD bank legend will reverse to a
negative image. Either rotate the main dial or use the [←] [→] keys to select the
memory bank. Press [ENT] when the desired bank number is displayed.
{figure 46}
3.4 Transfer data from memory to dial mode
While in memory channel mode, press the [FREQ] key (only a quick tap is required).
The frequency of the displayed memory channel will turn red, press [ENT].
{figure 47}
The frequency data will be transferred to VFO-A (which is always the bottom
displayed VFO while in memory recall mode).
{figure 48}
3.5 Memory data edit
Press the [EDIT] key while in the dial mode or memory channel mode. The memory
edit menu will be displayed.
{figure 49}
Each press of the [↑] or [↓] key will move the “>” (red cursor) up and down. Place
the cursor “>” along side the function which you would like to perform, followed by
[ENT].
3.5.1 Channel Edit and Delete
When the Ch Edit/Del menu is selected (as per section 3.5) the LCD will show:-
{figure 50}
A Selection of memory channel to edit
To Next Page
Loading...
