2. Input cursor
The cursor indicates the position where input will be made.
3. Select cursor
The select cursor indicates a selection of letter/number you want to input.
4. Command
Place the cursor over these commands followed by ENT to execute the following:-
Ins: Insert selected character
Del: Delete this character
Spc: Space (add a blank space)
Quit: Quit (exit this menu)
7.2 Key operation
Refer to the key sequence for the name editor as follows:-
[↑] key: Move the select cursor upward.
[↓] key: Move the select cursor downward.
[←] key: Move the input cursor to left.
[→] key: Move the input cursor to right.
Main dial: Move the select cursor left/right.
[ENT] key: Confirm the entry.
[ESC] key: Cancel the entry.
7.3 Write the name
Push the [ENT] key when the cursor is placed alongside the item “Name”. The name
editor screen will appear ready to accept your desired text ident. Use the [↑] and [↓]
keys to select character line number, use the main dial to move along each line, use
the [←] and [→] keys to move along the seven character text ident, use the [ENT]
key to accept the input for each character. Repeat the same key sequence until the
name is complete.
Place the select cursor over the “Quit” command followed by [ENT] to accept and
terminate the sequence. Push the [ESC] key at any stage to cancel the sequence
returning to whatever menu was in use before the name editor was selected. Other
options include Insert, Delete, and Space.
8 AV output
The AR7000 can be connected with external video monitor or audio equipment via
these sockets.
To Next Page
Loading...
