AOR AR7000 - Manual Search; Run; Ending the manual search

Note: When inputting start and stop frequencies, the AR7000 automatically assigns
the lower frequency to the START and upper frequency to the STOP regardless of
which order then are entered.
F End frequency
Push the [ENT] key when the cursor is placed alongside the item “Stop”. Enter the
desired stop frequency followed by [ENT].
{figure 91}
G Step
Push the [ENT] key when the cursor is placed alongside the item “Step”.
{figure 92}
Enter the desired step size via the keypad in a kHz order followed by [ENT].
Acceptable step size is anything between 0.01 kHz (10 Hz) and 1000 kHz (1 MHz),
invalid entries will be ignored. i.e. for a step size of 25 kHz, key [2] [5] [ENT]. Note
that this sequence is inoperative when automode (AUT) has been selected (as the
AR7000 CPU automatically selects step size using its pre-programmed bandplan
data).
H Receive mode (Mode)
Push the [ENT] key when the cursor is placed alongside the item “Mode”. Rotate the
main dial or push the [←] [→] keys to select the desired receive mode followed by
[ENT].
{figure 93}
I IF bandwidth (BW)
Push the [ENT] key when the cursor is placed alongside the item “BW” (this is to the
right of mode entry). Rotate the main dial or push the [←] [→] keys to select an
appropriate bandwidth followed by [ENT]. Note that this sequence is inoperative
when the auto mode (AUT) has been selected.
{figure 94}
J Auto store (Store)
Push the [ENT] key when the cursor is placed alongside the item “Store”. Rotate the
main dial or push the [←] [→] keys to select one of the following positions:-
{figure 95}