AOR AR7000 - Step; Receive mode (Mode)

{figure 122}
6.3.4 Operation of timer
Place the cursor alongside “Operation”, press [ENT]. The field initially displays “- - -“.
Rotate the main dial to alternate between “POWON” and “POWOFF”. Push the
[ENT] key to complete the sequence.
{figure 123}
A Setting the timer for switch-on
1. In the timer selection menu place the cursor alongside “Date” followed by [ENT].
Rotate the main dial to select the date required for switch on followed by [ENT]. The
current day is 00 with 31 being the maximum number of days ahead, selecting 00 will
cause the timer to event every day.
{figure 124}
2. Place the cursor alongside “Time” followed by [ENT]. Rotate the main dial to
select the hour/min, the [←] [→] keys are used to alternate between hours &
minutes. Complete the input with [ENT].
{figure 125}
3. Place the cursor alongside “Operation” followed by [ENT].
{figure 126}
Rotate the main dial to toggle between “POWON” and “POWOFF”. Select “POWON”
in this example followed by [ENT].
4. To arm the timer, place the cursor alongside “Power Off” followed by [ENT]. You
can alternatively push the [POWER] key from the infrared remote controller when
pointed at the AR7000 front panel sensor for the same effect.
{figure 127}
5. The AR7000 will immediately switch off and will automatically switch on at the pre-
set hour/day. The AR7000 front panel power switch must remain depressed and d.c.
power applied to the radio at all times while the timer is armed.
B Setting the timer for switch-off
1. In the timer selection menu, select the date the AR7000 is to be switched off.