EasyManuals Logo

APC 100 User Manual

APC 100
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
9
4: STORAGE, MAINTENANCE, AND TRANSPORTING
Storage
Store the UPS covered and positioned as for proper functioning, in a cool, dry location, with the bat-
teries fully charged.
At -15 to +30 °C (+5 to +86 °F), charge the UPS battery every six months.
At +30 to +45 °C (+86 to +113 °F), charge the UPS battery every three months.
Replacing the Battery Module
This UPS has an easy to replace, hot-swappable battery module. Replacement is a safe procedure,
isolated from electrical hazards. You may leave the UPS and connected equipment on for the follow-
ing procedure. See your dealer or contact APC at the web site, www.apc.com
for information on re-
placement battery modules.
Once the battery is disconnected, the connected equipment is not protected from
power outages.
Be careful during the following steps-the battery module is heavy.
Refer to Installing and Connecting the Battery and Attaching the Front Bezel, in this manual.
Refer to Mounting the UPS in a Rack (Steps 1 and 2) for instructions on battery removal.
Be sure to deliver the spent battery to a recycling facility or ship it to APC in the
replacement battery packing material.
Disconnecting the Battery for Transport
Always DISCONNECT THE BATTERY before shipping in compliance with U.S.
Department of Transportation (DOT) regulations.
The battery may remain in the UPS; it does not have to be removed.
1. Shut down and disconnect any equipment attached to the UPS.
2. Shut down and disconnect the UPS from the power supply.
3. Remove the front bezel, and unplug the battery connector, by pulling firmly on white battery
cord.
For shipping instructions and to obtain appropriate packing materials contact APC at the web site,
www.apc.com/support/contact
.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APC 100 and is the answer not in the manual?

APC 100 Specifications

General IconGeneral
ModelAPC 100
CategoryPower Supply
Output Power Capacity100VA/60W
Nominal Output Voltage230V
Nominal Input Voltage230V
Waveform TypeStepped approximation to a sinewave
Frequency50/60 Hz
Battery TypeLead-acid battery
Interface PortsUSB, Serial
Operating Temperature0°C to 40°C
Storage Temperature-15°C to 45°C
Humidity0% to 95% non-condensing
Audible Noise at 1mLess than 40 dB

Related product manuals