APC 100 User Manual

2
Positioning the UPS
Place the UPS where it will be used. The UPS is heavy. Select a location sturdy enough to handle
the weight.
Do not operate the UPS where there is excessive dust or the temperature and humidity are outside the
specified limits.
P
LACEMENT
Mounting the UPS in a Rack
The UPS is heavy. To lighten it, you may remove the battery before mounting the unit in the rack
(Steps 1 and 2).
Step 1
Step 2 Caution: The battery is heavy.
Step 3
Install the UPS at or near the bot-
tom of the rack (Step 3).
Check to ensure the rack will not
tip after installing the UPS into
the rack.
0º- 40ºC (32º-104ºF)
0-95% Relative Humidity
2.5 cm
(
1 in.
)

APC 100 Specifications

General

Model	APC 100
Category	Power Supply
Output Power Capacity	100VA/60W
Nominal Output Voltage	230V
Nominal Input Voltage	230V
Waveform Type	Stepped approximation to a sinewave
Frequency	50/60 Hz
Battery Type	Lead-acid battery
Interface Ports	USB, Serial
Operating Temperature	0°C to 40°C
Storage Temperature	-15°C to 45°C
Humidity	0% to 95% non-condensing
Audible Noise at 1m	Less than 40 dB