APC 250 User Manual

2
8.0 Storing the UPS ............................................................. 35
8.1 Storage conditions ........................................................................................ 35
8.2 Extended storage .......................................................................................... 35
9.0 Specifications................................................................. 36
9.1 Input................................................................................................................ 36
9.2 Transfer characteristics ................................................................................ 36
9.3 Output characteristics .................................................................................. 36
9.4 Battery and charger ...................................................................................... 37
9.5 Surge and noise suppression ...................................................................... 37
9.6 Operating Environment ............................................................................... 37
9.7 Physical........................................................................................................... 38
9.8 Approvals....................................................................................................... 38
9.9 Typical run times versus load ..................................................................... 38
Table of Contents

APC 250 Specifications

General

Nominal Output Voltage	230V
Nominal Input Voltage	230V
Waveform Type	Stepped approximation to a sinewave
Frequency	50/60 Hz
Battery Type	Lead-acid battery
Typical Recharge Time	6 hour(s)
Operating Temperature	0°C to 40°C
Storage Temperature	-15°C to 45°C
Humidity	0% to 95% non-condensing