To Next PageTo Next Page
Need help?Do you have a question about the APC BE750G Series and is the answer not in the manual?
General| Output Power Capacity | 450 Watts / 750 VA |
|---|---|
| Nominal Output Voltage | 120V |
| Topology | Line Interactive |
| Waveform Type | Stepped approximation to a sinewave |
| Input Voltage | 120V |
| Input Frequency | 50/60 Hz +/- 3 Hz (auto sensing) |
| Battery Type | Maintenance-free sealed Lead-Acid battery with suspended electrolyte |
| Interface Port | USB |
| Input Connection Type | NEMA 5-15P |
| Control Panel | LED status indicators |
| Output Connections | 8 x NEMA 5-15R |
| Audible Alarm | Alarm when on battery |
| USB Charging Ports | No |
| Transfer Time | 6ms typical |
| Typical Recharge Time | 8 Hour(s) |
Details voltage, frequency, brownout/over-voltage transfers, capacity, and amperage.
Covers on-battery voltage/frequency, transfer time, and surge protection.
Information on AC input, battery type, and average battery life.
Details physical attributes like weight, dimensions, operating temperature, humidity, and elevation.
FCC compliance statement regarding interference.
Explains protection and power for connected devices during outages.
Describes protection for devices connected only for surge suppression.
Introduces software for advanced power protection and management features.
Details operating system compatibility and Mac recommendations.
Instructions for installing the PowerChute software via CD or download.
Explains how master/controlled outlets work for energy saving.
Guide to adjusting threshold settings for master/controlled outlet operation.
Indicates the Back-UPS is supplying utility power to equipment.
Shows the Back-UPS supplying battery power to outlets.
Alerts that the battery is near a total discharge state.
Indicates battery is disconnected, needs charging, or replacement.
Signals an overload condition during battery operation.
Alerts to an overload condition while on utility power.
Indicates the battery is completely discharged.
Warns of a potential electrical hazard in the building wiring.
Explains low, medium, and high sensitivity settings for voltage fluctuations.
Addresses issues related to the Back-UPS failing to power on.
Troubleshoots situations where the Power On/Replace Battery LED is flashing.
Resolves issues where connected equipment unexpectedly loses power.
Explains the meaning of the Power On LED illumination and beeping.
Interprets the Power On LED flashing and beeping patterns.
Addresses problems with insufficient battery backup time.
Diagnoses and resolves building wiring fault indicators.
Troubleshoots loss of communication line signal through the Back-UPS.
Details steps for obtaining service, including contacting support and shipping.
