Need help?Do you have a question about the APC MGE Galaxy 3500 and is the answer not in the manual?
Details on AC input voltage, frequency, and current for different kVA ratings.
Specifications for the AC bypass input, including frequency and nominal current.
Details on cable lug types, crimping tools, die, and terminal bolt diameter.
Specifies the torque required for power wiring connections.
Diagram and components for a single utility/mains UPS system.
Diagram and components for a dual utility/mains UPS system.
Table of fuse and breaker sizes for single UPS systems.
Tables for fuse and breaker sizes in parallel capacity and redundant systems.
Details on required clearances for airflow and service access around the UPS.
Instructions on how to level the UPS cabinet using its feet.
Procedure to remove covers for accessing cable landing areas in UPS and XR Enclosures.
Explains how isolators separate busbars in XR Battery Enclosures and UPS.
Instructions for connecting AC input/output cables and neutral for single mains.
Instructions for removing busbars for dual mains connection.
Procedure for preparing the UPS for bottom cable entry, including removing covers.
Preparation steps for communication cables, including warnings.
Overview of PBus cables, their routing, and labeling in parallel UPS systems.
Note referencing removal of battery modules for cable preparation.
Describes three methods for routing communication cables between UPS units.
Instructions for installing seismic battery locks to secure batteries in seismic areas.
Details on required parts for installing seismic stabilizing brackets for UPS and MBP.
Procedure for installing battery securing brackets for stability in non-seismic areas.
Details on AC input voltage, frequency, and current for different kVA ratings.
Specifications for the AC bypass input, including frequency and nominal current.
Details on cable lug types, crimping tools, die, and terminal bolt diameter.
Specifies the torque required for power wiring connections.
Diagram and components for a single utility/mains UPS system.
Diagram and components for a dual utility/mains UPS system.
Table of fuse and breaker sizes for single UPS systems.
Tables for fuse and breaker sizes in parallel capacity and redundant systems.
Details on required clearances for airflow and service access around the UPS.
Instructions on how to level the UPS cabinet using its feet.
Procedure to remove covers for accessing cable landing areas in UPS and XR Enclosures.
Explains how isolators separate busbars in XR Battery Enclosures and UPS.
Instructions for connecting AC input/output cables and neutral for single mains.
Instructions for removing busbars for dual mains connection.
Procedure for preparing the UPS for bottom cable entry, including removing covers.
Preparation steps for communication cables, including warnings.
Overview of PBus cables, their routing, and labeling in parallel UPS systems.
Note referencing removal of battery modules for cable preparation.
Describes three methods for routing communication cables between UPS units.
Instructions for installing seismic battery locks to secure batteries in seismic areas.
Details on required parts for installing seismic stabilizing brackets for UPS and MBP.
Procedure for installing battery securing brackets for stability in non-seismic areas.
General| Dimensions (WxDxH) | 523 x 925 x 1499 mm |
|---|---|
| AC input voltage | 208/400 V |
| AC input frequency | 50 - 60 Hz |
| Cable color | Gray |
| Storage temperature (T-T) | 0 - 30 °C |
| Operating temperature (T-T) | -5 - 45 °C |
| Operating relative humidity (H-H) | 0 - 85 % |
Weight and Dimensions| Weight | 776000 g |
|---|
To Next Page
