APC RT User Manual

13
R
EPLACING BATTERY MODULES
X Y
Z [ \
] ^ _

Disconnecting the Battery for Transport
Always DISCONNECT THE BATTERY(s) before shipping in compliance with U.S.
Department of Transportation (DOT) and IATA regulations.
The battery(s) may remain in the UPS.
1. Shut down and disconnect any equipment attached to the UPS.
2. Shut down and disconnect the UPS from the power supply.
3. Unplug the battery connectors. Refer to Replacing Battery modules in this manual.
For shipping instructions contact APC at the Web site, www.apc.com
.

APC RT Specifications

General

Nominal Output Voltage	230V
Topology	Double Conversion Online
Input Voltage Range	160 - 286 V
Nominal Input Voltage	230V
Transfer Time	0 ms
Emergency Power Off (EPO)	Yes
Output Frequency	50/60 Hz +/- 3 Hz
Wave Type	Sine wave
Battery Type	Sealed Lead-Acid (SLA)
Interface Ports	USB
Audible Alarm	Alarm when on battery
Type	UPS
Form Factor	Rack/Tower convertible
Dimensions	432 x 482 x 89 mm (17 x 19 x 3.5 in)