8 / 60
Set Temp Operation
STX
‘ｃ’
Solder condition number … ETX SUM
Cleaning Operation
STX
‘ｃ’ ‘０’ ‘０’ ‘０’ ‘０’
Air blow time ETX SUM
11.3.7 D : Solder Condition Data Transfer Request
【Code】 ４４Ｈ(‘Ｄ’)
【Function】
Solder Condition Data Transfer Request
【Direction】
External controller → Soldering controller
【Data】
Solder condition number
Solder mode
SV2 setting temperature rising time
1st solder wire feeding amount
1st solder wire feeding speed
1st solder wire reversing amount
1st solder wire reversing speed
Pre-heating time
2nd solder wire feeding amount
2nd solder wire feeding speed
2nd solder wire reversing amount
2nd solder wire reversing speed
Heating time
3rd solder wire feeding amount
3rd solder wire feeding speed
3rd solder wire reversing amount
3rd solder wire reversing speed
000, 101～199, 201～299, 301～399
0, 1, 2, 3, 4, 5
4 Byte
1 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
3 Byte
【Explanation】
It sets a solder condition from external controller to soldering controller.
It is hexadecimal / 3 digits notation except for Solder condition number and Solder
mode.
If the data has a decimal point, the value that omitted decimal point is expressed in
hexadecimal.
Example 1: 3.5s⇒35(23H), Example 2: 10.0s⇒100(64H)
It is hexadecimal / 4 digits notation in Solder condition number.
It is hexadecimal / 1 digit notation in Solder mode.
The value divided by 10 after converted it to decimal numbers becomes the actual
setting value.
If it specifies a solder condition number that does not exist, it ignores the
command.
If it specifies a solder mode that does not exist, it ignores the command.
If a data is outside the range, it ignores the command.
The number of Solder mode is as following;
０： Special point soldering
１： Special slide soldering
２： Special soldering point soldering (without iron up motion)
３： Special easy slide soldering
４： Pre-solder
５： Set Temp
* The value in case of Point soldering and Slide soldering is not fixed.
To Next Page
Loading...