9
SV200 AC Servo Drive User Manual
920-0096H
2/6/2018
1 Introduction
1.1 About This Manual
This manual describes the SV200 Servo Drive.
It provides the information required for installation, configuration and basic operation of the SV200 series AC servo drive.
This document is intended for persons who are qualified to transport, assemble, commission, and maintain the equipment described
herein.
1.1.1 Documentation Set for SV200 series AC servo
This manual is part of a documentation set. The entire set consists of the following:
• SV200 User Manual. Hardware installation, configuration and operation.
• SVX ServoSUITE® User Manual. How to use the SVX ServoSUITE®.
1.1.2 Safety
Only qualified persons may perform the installation procedures. The following explanations are for things that must be observed in
order to prevent harm to people and damage to property.
The SV200 utilizes hazardous voltages. Be sure the drive is properly grounded.
Before you install the SV200, review the safety instructions in this manual.
Failure to follow the safety instructions may result in personal injury or equipment damage.
1.1.2.1 Safety Symbols
Safety symbols indicate a potential for personal injury or equipment damage if the recommended precautions and safe operating
practices are not followed.
The following safety-alert symbols are used on the drive and in the documentation:
Caution Warning. Dangerous voltage. Protective earth Caution, Hot surface
To Next Page
Loading...
Need help?
General