Aprilaire 8800 - Page 11

AUTOM
Auto changeover mode configuration COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] AUTOM<?<CR>
Description: Requests the auto mode changeover setting.
Assignment
Command
Syntax: SN[#] AUTOM=[value]<CR>
Description: Sets the auto mode changeover setting to [value].
Example: SN1 AUTOM=OFF<CR>
Response Syntax: SN[#] AUTOM=[value]<CR>
Example: SN1 AUTOM=ON<CR>
Node address 1 responds with an auto mode changeover setting of ON.
Parameters Range
value: Auto Mode Setting [OFF, ON]
OFF: disabled
ON: enabled
EQONTIME
Minimum equipment on time COS: N/A
Permissions: Read only
Query
Command
Syntax: SN[#] EQONTIME?<CR>
Description: Requests minimum equipment on time setting.
Response Syntax: SN[#] EQONTIME=[value]<CR>
Example: SN1 EQONTIME=2<CR>
Node address 1 responds with a minimum equipment on time of 2 minutes.
Parameters Range
value: minimum equipment on time in minutes [1 – 5]
Default: 2
HOFFTIME
Minimum heat equipment off time COS: N/A
Permissions: Read only
Query
Command
Syntax: SN[#] HOFFTIME?<CR>
Description: Requests minimum heat equipment off time setting.
Response Syntax: SN[#] HOFFTIME=[value]<CR>
Example: SN1 HOFFTIME=2<CR>
Node address 1 responds with a minimum heat equipment off time of 2 minutes.
Parameters Range
value: minimum heat on time in minutes [1 – 5]
Default: 2
11