FAN, F
Thermostat fan mode COS: C8
Permissions: Read/Write
Query
Command
Syntax: SN[#] FAN?<CR>
SN[#] F?<CR>
Description: Requests the thermostat fan mode.
Assignment
Command
Syntax: SN[#] FAN=[value]<CR>
SN[#] F=[value]<CR>
Description: Sets the thermostat fan mode to [value].
Examples: SN1 FAN=AUTO<CR>
SN1 F=CIRC<CR>
Response or
COS Message
Syntax: SN[#] F=[value]<CR>
Description: The thermostat sends the fan mode. The [value] parameter is always in the verbose format.
Example: SN1 F=ON<CR>
Node address 1 responds with a thermostat fan mode of ON.
Parameters Range
value: control mode codes [AUTO, A, ON, CIRC]
AUTO, A: fan auto mode
ON: fan on mode
CIRC: fan circulate mode
The fan mode can be changed through the Home Screens of the thermostat. If the control mode is changed at the thermostat, a C8 COS
unsolicited message is issued (if C8 is ON).
37
To Next Page
Loading...
