18
DS41242-001
4 INSTALLATION
READ THE INSTRUCTION CAREFULLY
Make sure the door structure is solid and suitable to be motor driven.
Make sure when the door is moving there are no friction point.
The door must be properly balanced and must be easily lowered and raised by hand.
Referring to Fig. 1 for recommended installation.
1) Guide 5) Programming panel
2) 24VDC flash light (optional) 6) Power socket
3) Wall switch (optional) 7) Door opener
4) Photo beam (optional)
Maintaining a minimum gap of 30mm from the top panel’s maximum height (Fig. 2).
Make sure the guide is horizontal and vertical to the shaft. Make sure the connection of hanging bracket F and
ceiling is firm enough (Fig. 3).
Warning: Make sure the opener is affixed to noggins in ceiling and not to plasterboard. Failure to have a safe and
secure fixing will lead to opener falling, and cause serious persons and /or property damage.
2
1
3
4
4
5
6
7
FIG.1
30mm
FIG.2
FIG.3
To Next Page
Loading...
